2008 Kenworth T660
Upgrade Your Product
Other Products for Your Vehicle
Product Description
FRAM Extra Guard® oil filters deliver advanced engine protection for everyday drivers who perform routine oil changes at OE (original equipment) recommended intervals. Equipped with SureGrip® technology, FRAM Extra Guard® oil filters provide a non-slip surface allowing for easy install and removal.
The silicone anti-drain back valve ensures safe engine startups, extending the life of the oil filter for up to 10,000 miles.
- Proven protection for up to 10,000 miles
- Engineered for use with synthetic or conventional motor oils
- SureGrip® technology for easy install and removal
- Filter media is a blend of fiber and resin that captures 95% of the dirt particles
- Silicone anti-drain back valve helps ensure safe engine start up
FRAM Extra Guard provides the perfect balance of dirt-trapping efficiency and dirt-holding capacity.
Product Specs
| Height | 3.430 |
| Inside Diameter | 3/4-16 Th'd |
| Outside Diameter | 2.984 |
| Anti-Drainback Valve | YES |
| By-Pass Valve Setting | 12 |
| Turning Specification | 3/4-1 |
| Base Gasket I.D. | 2.450 |
| Base Gasket O.D. | 2.760 |
| Base Gasket Thickness | 0.191 |
Where to Buy
Installation Instructions
View Components
Installation Instructions
- Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
- Place a drain pan under the oil filter and unscrew oil filter.
- Clean mounting base, making sure the O-ring from the old filter is not stuck to the filter mount.
- Apply film of clean oil to filter gasket. Do not use grease.
- Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
- Check owner's manual for correct oil specification, viscosity and amount.
- Add oil to "full" on dipstick. Idle engine for 5 minutes and check for leaks.
- Shut off engine and recheck oil level after 5 minutes and top off as necessary.
*FRAM Group testing of average filter efficiency of PH8A, 3387A and 4967 or equivalent FRAM TG or XG models under ISO 4548-12 for particles greater than 20 microns.
**Greater than 3X the functional life of Nitrile ADB when tested per SAE HS806 hot oil and Anti-drain-back test.
ꝉNot all features are available on every part number in the product line. Check the package for specific features of individual filters.
Upgrade Your Product
Other Products for Your Vehicle
Source: https://www.fram.com/parts-search/PH3614
0 Komentar